Guitar Tech screwdriver and wrench set

The Guitar Tech screwdriver and wrench set replaces a whole drawer full of tools. We've included 36 essential bits for fretted instrument hardware, plus an easy-grip handle with extender. The entire set comes in a durable compact spill-proof latching hard case that fits nicely into your toolbox or guitar case.

Contents:

• 6 Phillips bits: 000 • 00 • 0 • 1 • 2 • extra 1
• 11 Allen bits: .050" • 1/16" • 5/64" • 1/8" • 5/32" • 1.5mm • 2.0mm • 2.5mm • 3.0mm • 3.5mm • 4.0mm
• 11 flat-blade bits: 0.8mm • 1.2mm • 1.5mm • 1.8mm • 2.0mm • 2.5mm • 3.0mm • 3.5mm • 4.0mm • 5.0mm • extra 3.0mm
• Capture bit: 5.0mm non-slip flat-blade bit helps protect small screws and finished surfaces
• Adapter for 1/4" sockets: use with your socket set to install tuners and jacks
• Mini wire brush: remove corrosion from bridge saddles and more
• Awl point: mark starter holes for drill bits
• Hardened screw starters: #2 • #3 • #4 • #5; pre-thread screw holes in wood

Handle: The 4-1/2" easy-grip handle has a rotating cap for fingertip control. It's red, so it won't get lost on a crowded benchtop. The interchangeable steel bits snap easily into the magnetic shaft, and a handy 1-3/8" extender gives extra reach when you need it.

Case: The latching custom hard case is a mere 5" long, and fits conveniently into a guitar case or gig bag pocket—great for backstage setups and emergency repairs on the road. The case holds the bits snug so they won't spill out. Sizes are marked on the bits, and a handy chart in the case lid helps keep everything organized and easy to identify at a glance.

Get one for your guitar case!

In addition, there are three double-ended wrenches, providing six sizes guitar techs use all the time These three double-ended wrenches fit jacks, pots, switches, bridge studs, stompboxes… Just about every wrench you need for guitars and amps.

Quality hard-plated steel. Slim enough to slide under control knobs, and into tight spaces, but tough enough for professional repair shops.

Inches on one end, metric on the other

• 1/2" + 14mm: output jacks on acoustics and electrics; DC input jacks on effects pedals; our flush-mount jack
• 7/16" + 12mm: control pots and TonePros™ Locking Studs
• 3/8" + 10mm: amp chassis and speaker nuts; threaded tuner bushings

PS these are small enough to fit in most guitar cases - but not in the spill-proof latching case.